The dents that can’t be reached you can drill about one eighth inch hole in to the center of the car dent and screw the slide hammer into the hole and than you will be able to pull the dent out. You can also use a dent rod to finish pulling the dent out. Once the metal is almost back to normal then you sand the damaged area out to about two to three inches of the undamaged area with 80 grit sand paper. Repeat with 100 grit paper until down to the metal. Now on a clean surface mix up your filler with the hardener. Clean the damage area and apply the filler over the area quickly. Always apply quickly cause you don’t want it to start to dry.

Share and Enjoy:
  • Print
  • Digg
  • Sphinn
  • del.icio.us
  • Facebook
  • Mixx
  • Google Bookmarks
  • Blogplay